INFORMATION PORTAL > TECHNOLOGY GROUPS > Auxiliary systems optimization
Auxiliary systems optimization
Optimizing auxiliary systems to vessel specific operational profiles can lead to significantly reduced energy consumption. Auxiliary systems are often designed to support engines and other primary systems at extreme ambient conditions, or 100% load, which rarely occur. Most of these systems experience supporting primary engines and systems at loads from 80% and down, and with the era of slow steaming, the auxiliary systems typically support engines and systems at loads below 50%, as per Figure 1 which is a representative example.
Operating over a prolonged time at lower loads can induce accelerated wear and can increase the need, cost, energy consumption and complexity of maintenance.
Applicability and assumptions
Auxiliary systems optimization is applicable for all vessels with auxiliary systems, regardless of ship type and age. The measure includes full or partial assessment of the energy consumption and production in the vessel auxiliary systems. Through simulation and optimization potential to save energy and fuel can be revealed via
- speed control of pumps and fans
- control strategies of cooling water systems
- replacement of heat exchangers with new more efficient heat exchangers
- adjusted room ventilation, and better control strategies
- redesign of piping and instruments
- smarter utilization of heat recovery from the high-temperature and exhaust gas systems
- smarter sensor and power management systems controlling distribution and consumption of auxiliary energy
Auxiliary systems optimization can represent a wide range of measures, but the key message is that there exist large potentials in saving energy consumed by the vessel’s auxiliary systems. The cost and reduction potential estimate of this measure is highly dependent on whether or not the case is a newbuild or retrofit, the design point(s) distance to actual operating points, complexity in auxiliary system design, etc.
Cost of implementation
The cost of implementation is estimated at $10,000 to $150,000 (USD), spanning from simpler improvement to control of cooling water systems to partial redesign of piping system for cooling and steam, including smart energy automation systems.
The reduction potential is 1% to 5% of total ship fuel consumption where the reduction potential estimate is highly dependent on whether or not the case is a newbuild or retrofit, the design point(s) distance to actual operating points, complexity in auxiliary system design, etc.
- DNV GL Energy efficiency finder / Holistic approach to finding applicable energy efficiency measures to a specific vessel type.
*This Information Portal is still under development and further images will be added. For suggestions and additional technologies to be included in the Information Portal, please use the GreenVoyage2050 Contact Form.
This Energy Efficiency Technologies Information Portal was developed in cooperation with DNV GL.
This webpage serves as an Information Portal for Energy Efficiency Technologies for Ships. IMO does not make any warranties or representations as to the accuracy or completeness of the information provided. View our disclaimer